Send us a text

By providing your phone number, you consent to receive transactional/informational text messages (SMS) from Criz’s Concrete & Landscaping, powered by Topline Pro. You can unsubscribe at any time by replying STOP. Message and data rates may apply. Message frequency varies.

By submitting this form, you agree to our Terms of Service & Privacy Policy.

Concrete Slab Construction

Concrete Slab Construction in Colorado Springs, CO

Level, reinforced, properly drained. Criz's Concrete & Landscaping prepares the ground, sets the forms and pours slabs that hold up to Front Range freeze-thaw, for patios, pads and the base under whatever you build next.

Small square concrete pad with saw-cut control joints, formed and finished on bare ground

A square pad, saw cut and finished, on bare Colorado ground. Every slab starts as dirt and a plan.

What a slab is for

A slab is the flat, strong base under everything else

A concrete slab is a flat, poured pad that carries weight and stays level. In Colorado Springs that can be a patio behind a new-build house, a pad for a shed or a hot tub, a slab along the side of the house for an AC unit, or a base on open acreage out toward Elizabeth and Limon.

Front Range soil swells and shrinks with moisture, winters freeze and thaw, and the sun is hard on a fresh surface. So the work starts below the concrete: a graded and compacted base, forms set to the right slope, reinforcement where the job calls for it, and control joints cut so the slab cracks where we plan it to. Most slabs get a broom finish for traction. We confirm the right spec on site before we pour.


Four jobs we pour slabs for

  • Rectangular concrete pad poured along house siding beside a window well

    Utility and storage pads

    Shed, AC unit or trash bins: a level pad keeps a door swinging and a floor dry. We form it square and give it a little fall for runoff.

  • Large new broom-finish concrete patio slab with a curved corner behind a gray two-story house

    Patio slabs

    The most common slab we pour. Saw-cut joints, a broom finish for grip, and curves where the yard calls for them. See patio design.

  • Long broom-finish concrete slab with saw cuts running along a stucco house

    Slabs along the house

    Long, narrow runs beside stucco or siding need the right slope away from the wall. Drainage matters most here.

  • Finished monolithic concrete slab on open prairie land with trucks in the background

    Acreage and prairie pads

    Wide open lots east of town take a bigger base. For a footing and slab poured as one piece, see monolithic slab.

Inside a slab

What is under your concrete matters most

You only see the top inch. These five layers decide whether the slab is still flat and sound after ten Colorado winters.

  1. 01

    Finish and control joints

    A broom finish gives grip when it is wet or icy. Saw cuts guide the slab to crack along the lines, not across the middle of your patio.

  2. 02

    Concrete

    Poured into formed edges and leveled with a slight fall so water runs off and away from the house.

  3. 03

    Reinforcement

    Rebar or wire mesh, set inside the slab on supports so it sits in the concrete, not down in the dirt.

  4. 04

    Compacted base

    Gravel packed tight in layers. A solid base is what keeps a slab from settling and rocking over time.

  5. 05

    Prepared subgrade

    The native soil, cleared and graded. Colorado Springs clay moves with moisture, so this is where we plan for it.

Layer depths and reinforcement vary by job. We confirm the spec for your slab on site.

Crew member working inside wood forms with a concrete hose and rebar during a pour
On a pour day: the crew inside wood forms, with the concrete hose and rebar on the ground.

How a pour goes

From bare dirt to a finished slab in four steps

  1. 1

    Walk the site and quote it

    We look at the ground, the slope, access for trucks and what the slab will carry, then give you a free estimate.

  2. 2

    Excavate, compact and form

    We cut to depth, build a compacted base, set wood forms to the right fall and place the reinforcement.

  3. 3

    Pour and finish

    The concrete goes in, gets leveled and broom finished, and we cut the control joints at the right time.

  4. 4

    Cure and clean up

    We strip the forms, clean the site and tell you how long to keep off it before foot traffic and heavy loads.

Questions

Concrete slab questions, answered

Straight answers from the crew. Not sure what your yard needs? Ask for an estimate and we will look at it with you.

How much does a concrete slab cost in Colorado Springs?

It depends on the size, base prep, reinforcement, finish, grading and how easily trucks can reach the spot. A flat backyard costs less to prep than a sloped foothills lot. We do not guess a price from a photo. We look at the site and give you a free estimate for the whole job.

How thick should a concrete slab be?

Most residential patios are poured about 4 inches thick. A slab that will hold a shed, hot tub or vehicle may need more thickness and stronger reinforcement. We confirm the right spec for your job on site, based on what the slab will carry and what the ground is like.

What is the difference between a slab and a patio?

A slab is the poured base. A patio is a slab designed for living on, with a shape, a finish, steps and a layout that fits your yard. We build both. If you want an outdoor space rather than a plain pad, see our patio design and installation page.

How long does a slab take, and when can I use it?

Prep and forming usually take longer than the pour itself. Concrete keeps gaining strength for weeks after it is placed. We tell you when it is ready for foot traffic and when it can take heavy loads like a shed or a vehicle. Cold or hot weather can change that timing.

Will my new slab crack?

All concrete can crack, because it shrinks as it cures. We cut control joints, the straight saw lines you see on a patio, so any crack follows the joint instead of wandering across the surface. A compacted base and reinforcement also help the slab stay flat through freeze-thaw.

Do you pour slabs outside Colorado Springs?

Yes. We work in Colorado Springs, Woodland Park, Divide, Canon City, Pueblo County, Parker, Elizabeth, Limon and Denver. Mountain lots up Ute Pass and open acreage out east each need a different base plan, so we look at the property first.

Ready to pour your slab in Colorado Springs?

Tell us what you want to build on and where. We will look at the ground and give you a free estimate.